1. Disconnect a negative cable (-) of the rechargeable battery at the switched-off ignition. It is previously necessary to remove a box of the filter of air of salon.
2. Open a door of a back and remove its facing, address appropriate section.
|
3. Turn off 4 plastic nuts (1) of fastening of a back spoiler at the left and on the right. |
4. The Torx screw-driver one by one unscrew 3 screws (2) on several turns. 5. Disunite the socket of an additional stoplight. 6. Wring out inside lock levels and wring out from an assembly opening at back doors outside the plug socket of an additional stoplight. 7. Turn off serially to avoid deformations of a back spoiler, 3 screws (2).
|
Screws are located in a back spoiler and are turned out from a back door outside. |
8. Remove a back spoiler from a back door. When closing a door of a back you watch that did not warp in relation to a car roof. |