|
1. Mark with paint the provision of the corresponding forward wheel concerning a nave. It will allow to establish at assembly the balanced wheel in its former situation. Weaken bolts of fastening of a wheel before a car poddomkrachivaniye. Lift a forward part of the car, put it on supports and remove a forward wheel.
|
|
Lifting operation and installations of the car on supports is connected with danger! Therefore before carrying out operation study Poddomkrachivaniye's Section and towage of Introduction to the management. |
2. Remove a forward loker of a wing, address appropriate section.
3. Turn out a lock bolt between a wing and a bumper, disconnect and remove a bracket as it is described in the Section Removal and installation of a bumper.
4. Turn out bolts of fastening and remove an expansion clip of a cover of the bottom, and also facing of a longitudinal beam around a wing.
5. Disconnect by means of a plastic wedge an entrance level of doors from the holder of a clip and remove.
|
|
6. Enter a plastic wedge into a gap between a wing (1) and facing of a longitudinal beam (2) and take out facing from two holders of clips (the shooter on an illustration). |
7. Turn off 2 nuts (3) fastenings of a wing.
8. Open a cowl and establish it vertically.
|
|
9. Turn out bolts (1) and remove a wing (2). |
10. Disconnect a cover (3) and the sealing film (4). |
