Mercedes C-Class

1. Establish wheels directly.
2. Disconnect a negative cable (-) of the rechargeable battery at the switched-off ignition. It is previously necessary to remove a box of the filter of air of salon.

Before a detachment of a cable find out a protective code of the radio receiver if that is available, address the Section Replacement of the Rechargeable Battery. Surely observe security measures at the address with a safety cushion, address the Section of the Security measure during the works with a safety cushion.

3. Remove a steering wheel, address the Section Removal and installation of a steering wheel.

Lifting operation and installations of the car on supports is connected with danger! Therefore before carrying out operation study Poddomkrachivaniye's Section and towage of Introduction to the management.

4. Turn out screws of fastening (1) of a contact spiral at the standing directly forward wheels so that it was possible to take out a spiral. Do not unscrew screws completely. Otherwise the contact spiral is sorted and she should be collected on average situation again (work HUNDRED).

5. Carefully take out a contact spiral from the understeering switch. The socket of the understeering switch at the same time automatically undocks.
6. Turn out 3 screws.

7. Open sockets of the understeering switch (1) by compression and take out from the understeering switch.

1. Uncover under the dashboard, address appropriate section.
2. Disconnect the plug of the switch of a tempostat (2) from the ignition switch.

3. Take out the understeering switch with the switch of a tempostat if the last is established, and disconnect the plug from the understeering switch.

1. Make sure that wheels of the car stand directly.
2. Join the socket of the understeering switch and install the switch into place.
3. Insert 2 sockets into the switch and record.
4. If is available темпостат, join the socket of the switch of ignition and establish a cover under the dashboard, address appropriate section.
5. Fix the understeering switch by three screws.
6. Establish a contact spiral against the stop on a steering spindle. Fix the socket.

7. Fix 2 sockets. At the same time you watch that both markings coincided (shooters on an illustration).

8. Establish into place a steering wheel. At the same time observe security measures at the address with a safety cushion, address the Section of the Security measure during the works with a safety cushion.
9. Attach a cable of mass of the rechargeable battery at the switched-off ignition. Install into place a box of the filter of air of salon. If it is necessary, enter a code of the radio receiver and determine time on hours.