Mercedes C-Class

W203 since 2000 of release

Repair and operation of the car

Mercedes-Benz
+ Mercedes-Benz cars of class C (W-203)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   + Suspension bracket of forward wheels
   + Suspension bracket of back wheels
   + Angles of installation of wheels of the car
   - Steering and safety cushions
      Steering and safety cushions - general information and security measures
      Security measures during the works with a safety cushion
      Removal and installation of the block of a safety cushion on a steering wheel
      Removal and installation of a steering wheel
      Removal and installation of a tip of steering draft
      Removal and installation of a protective cover of the steering mechanism
+ Body
+ Onboard electric equipment

Security measures during the works with a safety cushion

The safety cushion consists of the sensor of collision, the generator of gas, the monitor a safety cushion and the pillow. The signal on inflation of a safety cushion is developed by the control unit.
The car is equipped with a safety cushion of the driver and forward passenger, and also side safety cushions, safety cushions around the head and natyazhitel of seat belts. The locations of safety cushions are, as a rule, designated by the inscriptions "SRS Airbag".

The children's seat focused against the movement of the car excepting a special children's seat in combination with the device of automatic recognition of a children's seat is not allowed to have on a seat of the forward passenger.

For reasons of safety any works with the parts belonging to system of a safety cushion and natyazhitel of a seat belt are not allowed to carry out.

Before removal and installation of the block of a safety cushion of the driver:

PERFORMANCE ORDER

1. Disconnect a negative cable (-) of the rechargeable battery at the switched-off ignition. It is previously necessary to remove a box of the filter of air of salon.

Before a detachment of a cable find out a protective code of the radio receiver if that is available, address the Section Replacement of the Rechargeable Battery.

2. Isolate a negative pole (-) of the rechargeable battery to exclude casual contact.
3. Establish wheels directly, and a steering wheel in average situation.
4. Before removal (contact) of the block of a safety cushion remove an electrostatic charge. For this purpose quickly concern the lock of a door or a body.
5. At connection of the rechargeable battery in interior of the car there should not be people.

General measures of safety

Never install components of an airbag of other car or other steering wheel. When replacing establish only new details.

Even after insignificant accident which did not lead to operation of a safety cushion hand over system of a safety cushion and a natyazhitel of a belt on check on HUNDRED Mercedes.

After operation of a safety cushion in a steering wheel surely replace a steering wheel, at operation of a side safety cushion replace a cover in facing of a door, at operation of a safety cushion of the forward passenger replace the dashboard.

The monitor needs to be replaced with a safety cushion surely after triple operation.

The safety cushion is allowed to be checked only for HUNDRED. It is impossible to apply to check of a pillow a control lamp, the voltmeter or an ohmmeter at all.

The safety cushion elements which fell from height more than 0.5 m need to be replaced surely.

It is necessary to protect safety cushion elements from impact of a heat or fire. Do not subject safety cushion elements to influence of temperature above + 100 °C.

Protect a safety cushion from contact with water, lubricant or oil. At hit of water, lubricant or oil immediately wipe a pillow.

After removal of a safety cushion you store it so that the soft party specified upward. At the return storage there is a danger of emission up at casual ignition of the generator of gas. Thereby there is a danger of traumatizing.

If in work the break becomes, it is impossible to leave a safety cushion unguarded.

It is not allowed to disassemble the safety cushion block. With malfunction it will be replaced completely. As the pillow contains explosive, it is necessary to store reliably it under supervision.

Before utilization of the car it is necessary to utilize safety cushion components. Utilization has to make the specialized enterprises.

When carrying out any works on the car with application of electric welding it is previously necessary to disunite the safety cushion control unit socket at the switched-off rechargeable battery.