Seats
Manual adjustment of provision of front seats
Adjustment is recommended to be made as follows:
1. Longitudinal movement of a seat
Raise the handle and establish a seat in situation at which pedals of an accelerator and a brake are conveniently reached.
2. Seat pillow inclination
Rotate the handle forward or back before achievement of the situation providing easy support of hips.
3. Seat height
Pull for the lever - raising of a pillow of a seat
Press the lever - lowering of a pillow of a seat
4. Back inclination
Rotate the handle until the seatback is not established in required position. For reasons of safety situation is recommended close to vertical.
|
|
At change of situation unload a back. |
Height of head restraints
|
|
5 Release of a head restraint |
Installation is higher: put forward a head restraint up.
Installation is lower: press the button of release (5) and lower a head restraint, having pressed it from above.
Establish a head restraint so that the nape leaned on it approximately at the level of eyes.
Adjust an inclination of a head restraint manually. Pull for or press a head restraint in front.
Electric adjustment of provision of front seats
Turn a key in the lock of ignition in situation 1 or 2.
At an open door of the driver adjustment of provision of a seat of the driver can be made at the inserted key.
Adjustment of provision of a seat of the forward passenger can also be made at one open door.
|
|
If adjustment of provision of a seat is made from situation for lying or from far removed situation, watch that back cosmetic mirrors were closed. |
Switches in forward doors
Adjustment of provision of seats is possible if the key in the switch of ignition is turned in situation 1 or 2 or the corresponding door is open.
The main adjustment is recommended to be made as follows:
1. Seat height
You translate the switch behind in the direction of an arrow until the highest situation is reached, at preservation of sufficient free space over the head.
2. Longitudinal movement of a seat
You translate the switch in the direction of an arrow until situation at which pedals of an accelerator and a brake are conveniently reached is reached.
3. Seat pillow inclination
You translate the switch in front in the direction of an arrow before achievement of the situation providing easy support of hips.
4. Back inclination
You translate the switch in the direction of an arrow until required position of a seatback is reached. For reasons of safety we recommend almost vertical position. Establish a steering wheel so that the hands lying on a steering wheel were slightly bent in elbows.
5. Height of head restraints
Height of head restraints is established at adjustment by the switch so that the nape found an emphasis on a head restraint approximately at the level of eyes.
Adjust an inclination of a head restraint manually. Pull or press a head restraint in front.
Release and fixing of backs of front seats
Function of assistance to landing
If the seat is in a back third of range of adjustment of provision of seats, then for simplification of landing in addition to a back also the seat pillow leans back forward. On models with electric system of adjustment of provision of seats the additional electric drive of lowering of a head restraint.
Folding of a seatback forward:
Turn the handle forward and then cast away a back forward.
The remark for models with manual adjustment of provision of seats:
Cast away a back to a seat forward, if necessary lower a head restraint.
Tilting of a seatback back:
Cast away a back back and press it for the purpose of fixing in provision of the movement.
On models with manual adjustment of provision of seats cast away a back back to a seat, if necessary lower a head restraint.
Heating of seats
Turn a key in the lock of ignition in situation 1 or 2.
|
|
At inclusion of too large number of consumers of the electric power or insufficient state of charge of the rechargeable battery the heater of seats can be disconnected. In this case blinks one or both control light-emitting diodes. |
At restoration of sufficient tension the heater of seats joins automatically.
The switch on the average console.
1. Mode of Normal Heating button
2. Mode of the Maximum Heating button
Press the button (1):
The red control light-emitting diode on the button lights up.
Mode of normal heating.
Approximately in 30 minutes the heater of seats is automatically switched off.
Press the button (2):
Both red control light-emitting diodes on the button light up. Mode of the maximum heating.
Approximately in 5 minutes automatic switching to the mode of normal heating is made.
Press the button (1) or (2) once again:
Any of control light-emitting diodes does not burn.
The heater of seats is switched off.
Head restraints of back seats
If back seats are occupied, move only with the established head restraints. Thereby the risk of getting injured by passengers on a back seat at accident decreases.
1 Key
Tilting:
Press a key (1). The head restraint leans back.
Installation up:
Cast away head restraints manually up (shooter) before fixing.
Inclination:
Head restraints can be recorded in 2 provisions. For this purpose press a key (1) and establish head restraints in required position. Establish a head restraint as it is possible closer to the head.
Height of head restraints
2 Release of a head restraint
Head restraints can be adjusted on height.
Installation is higher:
Put forward a head restraint up. If the head restraint was pushed up to the end, press the button releases (2).
Installation is lower:
Press releases (2) the button and lower a head restraint, having pressed it from above.
Removal and installation of head restraints
|
|
For simplification of installation and removal of head restraints slightly incline a seatback.
Front seats with manual adjustment, a many-placed back seat |
Removal of a head restraint:
Lift a head restraint up to an emphasis. Press releases (1) the button and extend a head restraint.
Installation of a head restraint:
Establish a head restraint so that the clamp of a fork was in the direction of the movement of the car at the left.
Press a head restraint down to fixing.
Electrically adjustable front seat
Removal of a head restraint
Move the switch (1) up and hold in this situation until the head restraint does not move forward up to the end. Extend a head restraint.
Installation of a head restraint
Press the switch (1) up within about 5 seconds.
Establish a head restraint so that the clamp of a fork was in the direction of the movement of the car at the left.
Press a head restraint down to fixing.
By means of the switch lower a head restraint down to an emphasis and lift its top against the stop.
|
