|
|
Mercedes C-ClassW203 since 2000 of releaseRepair and operation of the car |
|
|
Mercedes-Benz + Mercedes-Benz cars of class C (W-203) + Operation manual + Routine maintenance + Engine + Cooling system and heating + Power supply system and release + Engine electric equipment + Manual transmission + Automatic transmission + Coupling and power shafts + Brake system - Suspension bracket and steering Specifications + Suspension bracket of forward wheels + Suspension bracket of back wheels + Angles of installation of wheels of the car + Steering and safety cushions + Body + Onboard electric equipment 
|
Suspension bracket and steering General information and security measures
The car is equipped with a forward suspension bracket in the form of triangular cross levers and a back suspension bracket in the form of spatial lever system which main components are screw springs, the stabilizer of cross stability and gas-filled shock-absorbers. Elements of a forward suspension bracket together with the rack steering mechanism and support of the engine are located on a beam of the forward suspension bracket made of aluminum which is connected by bolt connections with a body. Security measures When performing repair or service a component of a suspension bracket and steering you can face a problem of an otvorachivaniye of the rusted bolts and nuts. These bolts and nuts located under the car bottom constantly are exposed to external influences. There is nothing surprising that over time they become covered by a rust and partially collapse. Do not try to unscrew by force fixture — you for certain damage it. Apply a large amount of the getting liquid (WD40 type) on the corresponding nut or a bolt and allow it to impregnate a rust. Remove with a wire brush all rust and pollution from visible carving parts of fixture. The sharp blow by the hammer on a nut through a drift can sometimes destroy the rust which is between carving parts of a bolt and a nut. However, striking a nut, you watch that the drift did not come off its surface and did not damage a bolt carving. Turning off the rusted nut or a bolt, use a long neck — it you increase the enclosed effort; however never establish a long neck on a key with a graggers as you can not only damage the returnable mechanism of a key, but also be traumatized. If the bolt or a nut does not turn away, try to hold on it slightly. If at a bolt/nut otvorachivaniye you used great efforts or damaged its head (its surface), at installation use new (new). As when performing the majority of the procedures described in this Chapter you should lift the car, prepare reliable support. For a poddomkrachivaniye use a cart hydraulic jack. It can be required by you and for posting of a suspension bracket component at implementation of this or that procedure.
|
|