Mercedes C-Class

1. Depending on model cast away a back seat forward or remove it, address appropriate section.
2. Remove a rug from a floor under a back seat.

The rug is extended at the seat which is cast away forward under a back and back facings of a threshold of a door.

3. Disconnect a cover of the adjusting device.
4. Completely release the parking brake and weaken a cable tension, address the Section of Check of the brake system. Adjustment of the parking brake.

5. Disconnect cables (1) and (2) from the adjusting device.

6. Squeeze plastic levels (arrows on an illustration) on the end of a cable and disconnect cables in places of pass them in the body bottom.

7. Disconnect a forward cable from a pedal of the parking brake (1). Squeeze plastic levels on the end of a cable and extend a cable from the holder (2) on a pedal.

8. Attach an auxiliary rope to the end of a forward cable.
9. Mark with paint the provision of back wheels concerning naves. It will allow to establish at assembly the balanced wheels in their former situation. Weaken bolts of fastening of a wheel before a car poddomkrachivaniye. Lift a back part of the car, put it on supports and remove back wheels.

Lifting operation and installations of the car on supports is connected with danger! Therefore before carrying out operation study Poddomkrachivaniye's Section and towage of Introduction to the management.

10. Remove a support of a back brake, address appropriate section.
11. Remove a brake disk of a back brake, address appropriate section.
12. Remove brake shoes of the parking brake, address appropriate section
13. Disconnect a back cable from the razzhimny lock of a parking drum brake.
14. Turn off bolts and uncover a motive compartment, address the Section Removal and installation of a cover of a motive compartment from the bottom.
15. Extend cables from passes to the bottom, disconnect from holders and remove.

1. Attach an auxiliary rope to the end of a forward cable. Stretch a cable for the end of a rope through holders and passes to the bottom.
2. Stretch a back cable through the holder and pass to the bottom.
3. Further installation is carried out in the sequence, the return to removal.
4. Establish into place back wheels so that the marks put at removal coincided. Previously grease with a thin layer of bearing lubricant the aligning wheel disk belt on a nave. Do not grease bolts of fastening of wheels. Replace rusty bolts. Wrap bolts. Lower the car on wheels and tighten bolts cross-wise the moment of 110 Nanometers.
5. Adjust the parking brake, address the Section of Check of the brake system. Adjustment of the parking brake.