Mercedes-Benz
+ Mercedes-Benz cars of class C (W-203)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
- Coupling and power shafts
+ Coupling
+ Driveshaft
+ Power shafts of wheels
- Differential
Dismantling and assembly of differential
Dismantling and assembly of a reducer of the main transfer and adjustment of gaps of gear wheels
Determination of thickness of adjusting laying and its installation in the reducer case
Check and adjustment of a gap of a flange
Dismantling and assembly of differential with automatic blocking
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Dismantling and assembly of differential with automatic blocking
Differential with automatic blocking
|
|
| And — the Block of frictional disks with the conducted gear wheel with a diameter of 185 mm |
|
Take a roller finger 19 and a finger of differential 16 by means of a drift from the case of differential 13
|
|
To all illustrations:
13 — the differential Case
14 — the Spherical washer
15 — Satellites
16 — a differential Finger
17 — Gear wheels of the drive of power shafts |
19 — the Roller finger
22 — the Frictional disk with a slip on the one hand
23, 23a — Frictional disks without slips
24 — Frictional disks with slips on both sides |
Fix frictional disks in the correct order on both gear wheels of the drive of power shafts 17
|
|
17 — the Gear wheel of the drive of a power shaft
22 — the Frictional disk with a slip on the one hand |
23, 23a — Frictional disks without slips
24 — Frictional disks with slips on both sides |
The differential with automatic blocking is shown on an illustration.
Dismantling
|
|
|
|
1. Fix the case of differential (13). |
2. Take a roller finger (19) and a finger of differential (16) by means of a drift from the case of differential (13).
|
|
3. Establish drifts (046) in gear wheels of the drive of power shafts (17). |
|
|
4. Turn satellites (15) with spherical washers (14) towards an opening and remove them. |
|
|
5. At first remove the right gear wheel of the drive of a power shaft (17) (it is shown in the established provision) with frictional disks. |
|
|
6. Remove the left gear wheel of the drive of a power shaft (17) (from the conducted gear wheel) with frictional disks. |
|
|
Assembly
|
|
|
1. Fix frictional disks in the correct order on both gear wheels of the drive of power shafts (17) and carefully grease frictional disks (22) and (24) universal gipoidny transmission liquid.
|
|
2. At first establish the left gear wheel of the drive of a power shaft (from the conducted gear wheel) with frictional disks, then establish the right gear wheel of the drive of a power shaft (17) with frictional disks and establish a drift (046) having paid attention that frictional disks without slips have ears (shooters). |
|
|
3. Install satellites (15) with spherical washers (14), using a drift (046), roll them until they are not established in the differential case. |
4. Install a differential finger by means of a drift in satellites and spherical washers.
5. Check the moment of friction of differential. It has to make the 80-160th.
6. Establish a finger of differential (16) and a roller finger (19).
7. Take differential from a vice. |
|
|
|
