Mercedes C-Class

W203 since 2000 of release

Repair and operation of the car


Mercedes-Benz
+ Mercedes-Benz cars of class C (W-203)
+ Operation manual
+ Routine maintenance
- Engine
   Check of a compression in engine cylinders
   Check of the engine by means of the vacuum gage
   Removal and installation of a cover of a motive compartment from the bottom
   + 4-cylinder petrol engines
   + 6-cylinder petrol engines
   + Diesel engines
   - Engine lubrication system
      Check of pressure of oil
      Removal and installation of the sensor of level of oil
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


a45480c7
Что такое артрит симптомы признаки и методы лечения




Removal and installation of the sensor of level of oil

Removal

 PERFORMANCE ORDER

1. Remove the lower cover of a motive compartment, address the Section Check of the Engine by means of the vacuum gage.
2. Merge motive oil or suck away it, address the Section Replacement of Motive Oil and Oil Filter.

3. Disunite the socket (1) of the sensor of level of oil (2).

4. Turn out bolts (3). Incline the sensor and take out it from the case pallet.


Installation

 PERFORMANCE ORDER

1. Install the oil level sensor with a new sealing ring and fix by its moment 14 Nanometers (at the new pallet of a case the moment of 10 Nanometers).
2. Join the socket.
3. Establish the lower cover of a motive compartment, address the Section Check of the Engine by means of the vacuum gage.
4. Fill in motive oil in system, address the Section Replacement of Motive Oil and Oil Filter.
5. Start and warm up the engine. Check the oil level sensor for tightness.


6-cylinder petrol engine

 PERFORMANCE ORDER

1. Remove the lower part of the pallet of a case.
2. Disconnect from below the oil level sensor (in front, near an oil absorption pipe), having unscrewed 2 Torx screws.
3. Fix the oil level sensor by the moment of 10 Nanometers.