Mercedes C-Class

W203 since 2000 of release

Repair and operation of the car



Mercedes-Benz
+ Mercedes-Benz cars of class C (W-203)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   - Suspension bracket of forward wheels
      Removal and installation of a depreciation rack
      Repair of a rack of a suspension bracket of forward wheels
      Adjustment of a gap in bearings of forward wheels
   + Suspension bracket of back wheels
   + Angles of installation of wheels of the car
   + Steering and safety cushions
+ Body
+ Onboard electric equipment


a45480c7





Removal and installation of a depreciation rack

Removal

 PERFORMANCE ORDER

1. Mark with paint the provision of a forward wheel concerning a nave. It will allow to establish at assembly the balanced wheel in its former situation. Weaken bolts of fastening of a wheel before a car poddomkrachivaniye. Lift a forward part of the car, put it on supports and remove a forward wheel.
2. Disconnect wires of the sensor of speed and the sensor of wear of brake shoes from a depreciation rack.

3. Turn off a nut (3) and disconnect connecting draft (2) from a depreciation rack (1).

Do not damage a dustproof cap, hold from a provorachivaniye a wrench a spherical finger (4) of connecting draft.

4. Turn off 2 bolts of fastening (4) depreciation racks (1) to the rotary lever and take out bolts.

5. Turn off a nut (5) and take out a bolt (6).
6 Fix a depreciation rack from falling after removal of the top fastening.

7. Turn off a nut (7) and disconnect a depreciation rack above from a support (6).

At removal of the left depreciation rack previously disconnect the tank of windscreen washer and take aside the attached hoses.

8. Remove a washer and an emphasis (8) and take out a depreciation rack from a wheel arch down.

 At the same time do not damage a brake hose.


Installation

 PERFORMANCE ORDER

1. Carefully enter a depreciation rack through a wheel arch into a support.
2. Establish into place an emphasis and a washer.
3. Tighten the top nut the moment of 60 Nanometers.
4. Fix a depreciation rack to a rotary fist. At the same time insert the top bolt so that the bolt head, looking in the direction of the movement, looked forward.
5. Then tighten at first the top nut (5) the moment of 200 Nanometers, holding a bolt from a provorachivaniye, and then the lower bolt (4) the moment of 110 Nanometers, address an illustration 3.4.
6. Fix a connecting bar on a depreciation rack by the new self-stopped nut and a washer the moment of 40 Nanometers.
7. Fix on a rack of a wire of the sensor of speed and the sensor of wear of a brake shoe.
8. Install into place the windscreen washer liquid tank if he acted, and fix by turn of the lever of a clamp.
9. Establish into place a forward wheel so that the marks put at removal coincided. Previously grease with a thin layer of bearing lubricant the aligning wheel disk belt on a nave. Do not grease bolts of fastening of a wheel. Replace rusty bolts. Wrap bolts. Lower the car on wheels and tighten bolts cross-wise the moment of 110 Nanometers.
10. If the depreciation rack was replaced with new, perform measurement of geometrical parameters of a running gear.